Universal Pusher Adjustable Motor Mount 35 / 42mm Outrunner

Our Universal Pusher  two piece mount is CNC machined from billet aluminum.  It is designed to adapt a large range of 35mm and 42mm diameter outrunner motors to your pusher style plane.  It will allow for four different motor mounting heights to accommodate propeller sizes up to 3" diameter over stock.

The aluminum Base Plate can easily be attached to wood, metal, or foam.  The aluminum Motor Plate can then be mounted at the desired height to accommodate larger propeller sizes.  This will allow you to run a lower KV motor  for more thrust and better efficiency.  A perfect combination for FPV pilots looking for longer flight times and a more quiet platform.

With the aluminum base permanently mounted to your nacelle, swapping motors can easily be done without risk of stripping screw holes and damaging the nacelle.  This is ideal for those looking to achieve the best performance possible out of their model.

Position 1: stock height
Position 2: (+) 0.47"
Position 3: (+) 0.95"
Position 4: (+) 1.42"

Installation Instructions:

1. Install Motor Base to the nacelle using the 4 supplied screws or glue.
      (When attaching directly to foam a good 5min epoxy is recommended)
2. Attach new motor to Motor Plate with suppled flat head screws.
3. Attach Motor Plate to Motor Base at desired height with suppled pan head screws.

Included: 1 - AP 19x30 Motor Base and SSS Motor Plate, 4 motor screws, 4 motor plate screws,  4 base plate screws.

Total Weight: 30g

Base Plate Dimensions: 

Width: 2.10"  (53.4mm)
Height: 1.55"  (39.4mm)
Thickness: .125" (3.2mm)

Notes:

If a change in thrust angle is desired, simply add a small washer between the motor base and motor plate at the appropriate locations.

Center of Gravity should always be checked and adjusted per the user manual after installation of a new motor.

Compatible Motors

• 35mm Outrunners
• 42mm Outrunners

Due to the large variety of compatible motors Please verify motor size and KV will suite flying style

Acceptable bolt patterns (units in mm):

• 19x19
• 19x25
• 25x25
• 25x30
• 30x30

Please contact us with any questions on motor compatibility

Write a review